In the event this product proves to be defective within one year from the date of purchase, Behr Process Corporation will, at its option and upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or refund the original purchase price of this product to you.
For optimum performance, film uniformity, leveling and to cover cracks, a second coat MUST be applied.įor one year from the date of purchase, Behr Process Corporation warrants to the original consumer purchaser, (1) that the product meets Behr Process Corporation’s manufacturing specifications, and (2) the performance of this product when applied according to the label instructions and specifications.When spraying horizontal surfaces, follow the standard spread rate of 75 sq.When spraying vertical surfaces, apply a very thin coat (one pass only) and do not back brush/roll.035" tip with no mesh filter at 2400-3200psi. Airless spray is recommended for experienced applicators only use a.For vertical surfaces such as railings, use a nylon/polyester brush or roller and apply two thin coats at a spread rate of 400 sq.For a smoother texture, use a brush or thinner nap roller (i.e. Use pressure while rolling and apply a generous, even coat using a 1/4-1/2" nap roller. For edges, corners and in between wood boards, apply using a nylon/polyester brush.Deep nail holes and cracks may require additional filling. For nail holes and cracks up to 1/4", completely fill in with DeckOver coating using a nylon/polyester brush and allow to dry prior to rolling.Stir product occasionally throughout application.Intermix multiple containers to ensure color uniformity.Do not use if rain is expected within 24 hours. During application, avoid exposure of container to direct sunlight.Use product when air and surface temperatures are between 50-90˚ F (10-32˚ C).990 Concrete & Masonry Degreaser & Cleaner on sound coated surfaces prior to coating. Use an etcher product to clean and etch uncoated concrete or NO.Use a stripper product to strip peeling coating.Concrete Surfaces: Avoid areas that are structurally weak or subject to hydrostatic pressure above 8 psi.
Rinse thoroughly and allow to dry before coating. 63 to remove mill glaze and open the pores of the wood. 63) to remove all loose wood fibers, peeling paint/stain or deteriorated coatings prior to application of DeckOver. 64 Wood Stain & Finish Stripper (must be followed by NO.
Remove mildew stains, dirt, oil and grease with a product such as BEHR PREMIUM® NO.
0 kommentar(er)
